TP-Link JetStream 24-Port Gigabit L2 Managed Switch with 4 SFP Slots, Supports 24 Gigabit RJ45 ports, Rackmount (TL-SG3428)

Product Information

The question mark not only helps complete the command, but also helps display a list of available commands for each command mode, or a list of relevant keywords and arguments for any command.

IGMP Snooping helps the switch maintain a multicast forwarding table by snooping the IGMP transmission between the host and the IGMP Querier. With the forwarding table, the switch can forward multicast data only to the ports that are in the corresponding multicast group, to constrain the flooding of multicast data in the Layer 2 network. A firmware update can resolve issues that the previous firmware version may have and improve its current performance. To Upgrade Come gestire i dispositivi Omada in diversi siti utilizzando il Controller Omada SDN via VPN (Controller 5.0 o successivo) 05-02-2023 17174 V2: 1589.31 BTU/hr (110 V/60 Hz) (with 384 W PD connected); 117.38 BTU/hr (110 V/60 Hz) (no PD connected)

Driver

Normally, all switch ports are member ports of VLAN 1. If you do not want to remove a port from VLAN 1, you need to additionally configure it.

In summary, to set a port as an access port for a certain VLAN, take VLAN 100 as an example, the common configuration is: If your computer has a serial port (COM), please connect it to the console port (RJ45) of the switch, with the RJ45 console cable.With Fast Leave enabled on a VLAN, the switch will remove the (Multicast Group, Port, VLAN) entry from the multicast forwarding table before forwarding the leave message to the querier. This helps to reduce bandwidth waste since the switch no longer sends the corresponding multicast streams to the VLAN of the port as soon as the port receives a leave message from the VLAN.

To avoid wireless disconnect issue during firmware upgrade process, it's recommended to upload firmware with wired connection unless there is no LAN/Ethernet port on your TP-Link device.

Software-Defined Networking (SDN) with Cloud Access

This chapter will introduce some CLI basics, including how to access the CLI, switch port types, command abbreviations, auto-completion, etc.